Rockwell Automation 48MS MultiSight Vision Sensor - Manual (Page 25)

MultiSight™ User Manual
Start-up
10000000877(02) 25
Command Description
Run/Stop Run  Evaluation mode (MultiSight is automatically in Run mode when not connected to
the software)
Stop  Configuration mode. Configuration parameters can only be changed in this mode.
Trigger Manual triggering of MultiSight image evaluation (active only in “Run” mode and if Trigger
parameter is set to “triggered” (see “Detector Parameters” on page 32) or when triggered
image button in image section is pushed).
Save Save the detector configuration for one detector or all detectors.
Load Load previously saved detector configuration(s).
Reset The configuration parameters for a single detector or for all detectors are reset to the default
settings.
Copy Copy the configuration of one or many parameters from one Source Detector Configuration
to other detectors.
Logically linked or grouped detectors must have identical settings for certain parameters
(see page 28). Recommended procedure:
1.
Set the parameters of one detector to the desired configuration
2. Press the Copy button
3. In the Copy command pop-up window, select the configured detector from the
Source Detector Configuration drop-down list.
4. Select the detectors along the left side of the window that need to match the Source
Detector Configuration (e.g., detectors that are logically linked or grouped with the
source detector).
5. Select Default Par. at the bottom right of the window. This automatically selects all
the parameters that need to match for logically linked or grouped detectors.
6. Press the OK button to copy the Source Detector Configuration to the other selected
detectors.
Write to Flash Memory Writes all detector parameter settings to nonvolatile flash memory so that they are
maintained if the sensor loses power.