Rockwell Automation 20-COMM-L LonWorks Adapter - Manual (Page 11)

20-COMM-L LonWorks Adapter User Manual
Publication 20COMM-UM008B-EN-P
Chapter 1
Getting Started
The adapter is intended for installation into a PowerFlex 7-Class drive and
is used for network communication.
When used with PowerFlex 750-Series drives, the 20-COMM-L adapter
must have firmware revision 1.007 or later, and must be installed using the
20-750-20COMM or 20-750-20COMM-F1 Communication Carrier Card.
There are operating limitations and this manual does not include
information on using the 20-COMM-L adapter with PowerFlex 750-Series
drives.
Components
Topic Page
Components 1-1
Features 1-2
Compatible Products 1-3
Required Equipment 1-3
Safety Precautions 1-5
Quick Start 1-6
Item Part Description
➊ Status Indicators Three status indicators that indicate the status of the DPI, adapter, and
network connection. See Chapter 5 , Troubleshooting .
➋ DPI Connector A 20-pin, single-row shrouded male header. An Internal Interface cable
is connected to this connector and a connector on the drive.
➌ Terminal Block A 6-screw terminal block to connect the LonWorks network cable.
➊
➋
➌