Applying power, Start-up status indications, Applying power -5 – Rockwell Automation 20-COMM-L LonWorks Adapter User Manual
Page 21
Installing the Adapter
2-5
20-COMM-L LonWorks Adapter User Manual
Publication 20COMM-UM008B-EN-P
Applying Power
Install the drive cover or close the drive door, and apply power to the drive.
The adapter receives its power from the connected drive. When you apply
power to the adapter for the first time, its topmost ‘PORT’ status indicator
should be steady green or flashing green after an initialization. If it is red,
there is a problem. See
Start-Up Status Indications
Status indicators for the drive and communication adapter can be viewed on
the front of the drive (
Figure 2.4
) after power has been applied. Possible
start-up status indications are shown in
Table 2.A
.
Figure 2.4 Drive and Adapter Status Indicators (location on drive may vary)
!
ATTENTION: Risk of equipment damage, injury, or death
exists. Unpredictable operation can occur if you fail to verify that
parameter settings are compatible with your application. Verify
that settings are compatible with your application before applying
power to the drive.
➋
➊
PORT
MOD
STS
NET A
NET B