Rockwell Automation 20-COMM-L LonWorks Adapter - Manual (Page 13)

Getting Started 1-3
20-COMM-L LonWorks Adapter User Manual
Publication 20COMM-UM008B-EN-P
Compatible Products At the time of publication, the adapter is compatible with the following
products:
Required Equipment Some of the equipment that is required for use with the adapter is shipped
with the adapter, but some you must supply yourself.
Equipment Shipped with the Adapter
When you unpack the adapter, verify that the package includes the
following:
• PowerFlex 70 drives with standard or enhanced control • PowerFlex 750-Series drives (1)
• PowerFlex 700 drives with standard or vector control • PowerFlex Digital DC drives
• PowerFlex 700H drives • SMC™ Flex smart motor controllers
• PowerFlex 700S drives with Phase I or Phase II control • SMC-50 smart motor controllers
• PowerFlex 700L drives with 700 vector control or 700S control
(1) The 20-COMM-L adapter can be used with PowerFlex 750-Series drives, but the adapter must have firmware revision
1.007 or later. Also, the adapter has the following limitations and differences:
- Only the first 16 bits of the Logic Command and Logic Status words are used.
- Only drive Ports 0…6 are supported.
- Controller must be capable of reading/writing 32-bit floating point (REAL) values.
- Speed Reference/Feedback scaling are Hz (or RPM) x 1000 (depending on the setting of drive
parameter 300 - [Speed Units].
Please see the PowerFlex 750-Series AC Drives Programming Manual, publication 750-PM001, for drive parameter
information.
❑ One 20-COMM-L adapter
❑ One 2.54 cm (1 in.) long and one 15.24 cm (6 in.) long Internal
Interface cable (only one cable is needed to connect the adapter to the
drive; for which cable to use, see
Figure 2.1 on page 2-2 )
❑ One 6-screw terminal block (connected to the adapter)
❑ Resource files on digital media
❑ One PowerFlex 7-Class DPI (Drive Peripheral Interface) Network
Communication Adapter Installation Instructions, publication
20COMM-IN004
TIP: When mounting the 20-COMM-L adapter in a PowerFlex 750-Series
drive, you must use a 20-750-20COMM or 20-750-20COMM-F1
Communication Carrier Card, publication 750COM-IN001—and the
20-COMM-L adapter must have firmware revision 1.007 or later.