User-supplied equipment – Rockwell Automation 20-750-PNET Profinet Single Port Option Module User Manual
Page 14
14
Rockwell Automation Publication 750COM-UM006A-EN-P - January 2013
Chapter 1 Getting Started
User-Supplied Equipment
To install and configure the option module, you must supply:
❑ A small screwdriver
❑ A Profinet cable. See Profinet Installation Guideline for Cabling and
Assembly for details.
❑ One field-terminable RJ45 Profinet connector with CAT.5e performance
Important
: Profinet connectors are available from a variety of sources and
in various sizes. As such, there may be mechanical limitations that prohibit
the use of some connectors. We recommend the LAPP GROUP connector
part number 21700540 for use with PowerFlex 750-Series drives.
❑ Drive and option module configuration tool, such as the following:
– PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM
– Connected Components Workbench software, version 1.02 or later
Connected Components Workbench is the recommended stand-alone
software tool for use with PowerFlex drives. You can obtain a free copy
by:
• Internet download at
• Requesting a DVD at
Your local distributor may also have copies of the DVD available.
Connected Components Workbench software cannot be used to
configure SCANport-based drives or Bulletin 160 drives.
– DriveExplorer software, version 6.01 or later
This software tool has been discontinued and is now available as
freeware
at
. There are no plans to provide future updates to this tool
and the download is being provided ‘as-is’ for users that lost their
DriveExplorer CD, or need to configure legacy products not supported
by Connected Components Workbench software.