Rockwell Automation 20-750-PNET Profinet Single Port Option Module - Manual (Page 27)

Rockwell Automation Publication 750COM-UM006A-EN-P - January 2013 27
Chapter
3
Configuring the Option Module
This chapter provides instructions and information for setting the parameters to
configure the option module.
For a list of parameters, see Appendix B , Option Module Parameters . For
definitions of terms in this chapter, see the Glossary .
Configuration Tools The option module stores parameters and other information in its own
nonvolatile storage (NVS) memory. You must, therefore, access the option
module to view and edit its parameters. The following tools can be used to access
the option module parameters.
Topic Page
Configuration Tools 27
Using the PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM to Access Parameters 28
Setting the IP Address, Subnet Mask, and Gateway Address 28
Setting a Master-Slave Hierarchy (Optional) 30
Setting a Fault Action 33
Setting Web Page Access 35
Resetting the Option Module 36
Restoring Option Module Parameters to Factory Defaults 37
Viewing the Option Module Status Using Parameters 37
Updating the Option Module Firmware 38
Tool See
PowerFlex 20-HIM-A6 or
20-HIM-C6S HIM page 28
Connected Components Workbench
software, version 1.02 or later http://www.ab.com/support/abdrives/webupdate/
software.html
, or online help (installed with the software)
DriveExplorer Software,
version 6.01 or later http://www.ab.com/drives/driveexplorer , or online help
(installed with the software)
DriveExecutive Software,
version 5.01 or later http://www.ab.com/drives/drivetools , or online help
(installed with the software)
IMPORTANT For the HIM screens shown throughout this chapter, the option module
was installed in drive Port 4. If your option module is installed in a
different drive port, that port would appear instead of Port 4.