Rockwell Automation 20-750-PNET Profinet Single Port Option Module - Manual (Page 19)

Rockwell Automation Publication 750COM-UM006A-EN-P - January 2013 19
Chapter
2
Installing the Option Module
This chapter provides instructions for installing the option module in a
PowerFlex 750-Series drive.
Preparing for an
Installation Before installing the Option Module, do the following:
• Read the Profinet Installation Guideline for Cabling and Assembly.
• Verify that you have all required equipment. See
Required Equipment on
page 13 .
Topic Page
Preparing for an Installation 19
Setting the IP Address Selection Jumper 20
Connecting the Option Module to the Drive 21
Connecting the Option Module to the Network 21
Applying Power 22
ATTENTION: Risk of equipment damage exists. The option module
contains electrostatic discharge (ESD) sensitive parts that can be damaged
if you do not follow ESD control procedures. Static control precautions are
required when handling the option module. If you are unfamiliar with static
control procedures, see Guarding Against Electrostatic Damage,
publication
8000-4.5.2 .