Rockwell Automation 20-750-PNET Profinet Single Port Option Module - Manual (Page 39)

Rockwell Automation Publication 750COM-UM006A-EN-P - March 2013 39
Chapter
4
Configuring the Profinet Master
Profinet Masters are available from several manufacturers. This chapter provides
instructions on how to use the Profinet Master configuration tool to:
• Configure the Profinet Master
• Install the 20-750-PNET GSDML file
• Configure the 20-750-PNET option module as a PowerFlex 750 Profinet
slave
Example Network In this example, we will configure one PowerFlex 750-Series drive with a 20-750-
PNET option module, to be assigned as Station 1 on a Profinet network. This
configuration is used as an example system throughout the rest of this manual.
Most drives will have identical configurations apart from its IP address and
option module mapping. A drive is identified by the IP address on a Profinet
network. This chapter describes the steps to configure a simple network as shown
below.
Topic Page
Example Network 39
Configure the Profinet Controller 40
GSDML Installation 41
Slave Configuration 42
PowerFlex 750-Series Drive
Station 1
Profinet Master
Station 0