Rockwell Automation 21G PowerFlex 755 Transition Section and Splicing Kit - Manual (Page 15)

Rockwell Automation Publication 750-IN027C-EN-P - November 2013 15
PowerFlex 755 Transition Section and Splicing Kit for Floor-mount Drives and CENTERLINE 2100 Motor Control Centers
3. Bring the transition section and MCC column together.
4. Pass the 1/4-20 x 0.5 in. hex-head thread-forming screws from inside the
transition section through the joining holes and engage the screws with the
➊ holes in the MCC column.
5. Pass the 1/4-20 x 1 in. screw from inside the MCC column through the
transition section joining hole
➋ and secure with the 1/4-20 steel nut.
6. Make sure cabinets are level and pushed together tightly.
7. Tighten the screws in a uniform pattern.
IMPORTANT Do not use hardware to draw cabinets together.
1/4-20
6.2 N•m (55 lb•in)
10 mm