Rockwell Automation 21G PowerFlex 755 Transition Section and Splicing Kit - Manual (Page 8)

8 Rockwell Automation Publication 750-IN027C-EN-P - November 2013
PowerFlex 755 Transition Section and Splicing Kit for Floor-mount Drives and CENTERLINE 2100 Motor Control Centers
3. Bring the transition section and drive cabinet together.
4. Pass the M6 x 16 mm hex-head thread-forming screws from inside the
transition section through the joining holes and engage the screws with the
➊ holes in the drive cabinet.
5. Make sure cabinets are level and pushed together tightly.
6. Tighten the screws in a uniform pattern.
IMPORTANT Do not use hardware to draw cabinets together.
M6
6.2 N•m (55 lb•in)
10 mm