Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 15)

3
Chapter
3-1
Local and Serial Port Parameters
Firmware Version 1.01Ć3.01
The 1336VT drive logic uses a set of 90 user parameters to select and
control drive operation. Seventy-one of these parameters are accessible
through any of the Programming and Display Panels. All 90 are accessible
through the Serial Port.
Initial values for each parameter have been preset at the factory and are
shown in the following displays. Any interaction or preconditions required
for setting parameters are included in the following descriptions.
Enter
When using any Programming and Display Panel, pressing the Enter
pushbutton will access programming when parameter 0 is displayed. When
using the chassis mounted Local Programming and Display Panel, switch
SW1 on the panel must also be set to C1. In either case, in the
programming mode a decimal point will be shown at the right edge of the
display.
Enter
To store a changed value, the Enter pushbutton must be pressed first, if not,
the previous value will be restored to memory.
To end programming, both the s t pushbuttons must be pressed and held
down simultaneously.
Stop
After exiting the programming mode, the stop command must be cycled to
reset the drive and confirm that programming is complete. The decimal
point will not be displayed when not in the programming mode.
Parameter 0 -- Parameter Mode
Freq P R
P R Enter None
0
0
0
Read Only
Units
Minimum Value
Maximum Value
Factory Setting
The first parameter displayed when either viewing or programming a
parameter at a Programming and Display Panel.