Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 65)

Local and Serial Port Parameters
Firmware Version 2.01-3.01
Chapter 5
5-2
Parameter 72 -- Activate
Parameters 73Ć76
Freq P R
P R Enter Off/On
0
1
0
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
If set to 1, this parameter will allow Preset Frequencies 73-76 to be used.
Individual preset frequencies are selected by the setting of switches SW1
and SW2, and the Speed Select input at terminal block TB3 of the drive. A
table listing SW1, SW2, and Speed Select combinations is shown in
Chapter 3 –– Parameter 26. If the serial input to the drive is used,
Parameters 56 (Serial Input) and 57 (Serial Mask) will also determine the
selection of Preset Frequencies 73-76.
Parameter 73 -- Preset
Frequency 4
Freq P R
P R Enter Hertz
.0
250
.0
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
The value of this parameter is the command frequency when Preset
Frequency 4 is selected.
Parameter 74 -- Preset
Frequency 5
Freq P R
P R Enter Hertz
.0
250
.0
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
The value of this parameter is the command frequency when Preset
Frequency 5 is selected.