Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 17)

Local and Serial Port Parameters
Firmware Version 1.01-3.01
Chapter 3
3-3
Parameter 3 Ċ Output Power
Freq P R
P R Enter % of Rated Output Power
0
200
0
Read Only
Units
Minimum Value
Maximum Value
Factory Setting
When this parameter is selected for viewing, the output power of the drive
as a % of rated output power can be viewed while the drive is running.
Refer to the % Power/HP Conversion Tables in Chapter 8, or the %
Power/kW Conversion Tables in Chapter 9 for quick conversions.
Important: The displayed output current is an approximate value
calculated from drive internal calculations. Motor characteristics will affect
the accuracy of the output current indication.
Parameter 4 -- Last Fault
Freq P R
P R Enter Fault Code
0
37
0
Read Only
Units
Minimum Value
Maximum Value
Factory Setting
This parameter will always display the same value as shown in Parameter
86 even after the drive fault has been reset. Since Parameter displays 4 and
86 are identical but Parameter 86 is programmable, Parameter 4 will show
whatever value has been entered in Parameter 86.
If a value has not been entered in Parameter 86, the Fault Code for the last
drive fault that occurred will be shown. Both parameters are updated by the
drive each time a new fault occurs. Refer to the 1336VT User Manual for
Fault Code definitions.