Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 61)

Serial Port Parameters
Firmware Version 1.01-3.01
Chapter 4
4-11
Parameter 62 Ċ Frequency Source
Read Only
Units Code
Min Value 0
Max Value 13
This parameter reports to the drive which frequency source is currently
being used to command the drive.
0 — Local speed pot
1 — 0 to +10V input
2 — 4 – 20mA input
3 — Pulse train input
4 — Serial input
5 — Remote speed pot input
6 — Jog selected
7 — Preset Speed 1
8 — Preset Speed 2
9 — Preset Speed 3
10 — Preset Speed 4
11 — Preset Speed 5
12 — Preset Speed 6
13 — Preset Speed 7
Parameter 63 Ċ Pulse Input
Read and Write
Units Hertz
Min Value 0.00
Max Value 250.00
This parameter represents the output frequency to be produced by the pulse
input at TB2, Terminal 8.
Parameter 64 Ċ Serial Frequency
Read and Write
Units Hertz
Min Value 0.00
Max Value 250.00
Factory Setting 0.00
This parameter sets the output frequency that will be used as the Command
Frequency when serial communication is used for speed commands.