Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 68)

Local and Serial Port Parameters
Firmware Version 2.01-3.01
Chapter 5
5-5
Parameter 78 -- Traverse Period
Freq P R
P R Enter Seconds
0
30
0
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
This parameter is not typically used in variable torque applications and
should not be changed from its factory setting.
Parameter 79 -- Maximum
Traverse Freq P R
P R Enter Hertz
.0
100
.0
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
This parameter is not typically used in variable torque applications and
should not be changed from its factory setting.
Parameter 80 -- Inertia
Compensation Freq P R
P R Enter Hertz
.0
20.0
.0
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
This parameter is not typically used in variable torque applications and
should not be changed from its factory setting.