Rockwell Automation 1336F PLUS II User Manual - Firmware 1.xxx-6.xxx - Manual (Page 195)

Dimensions B–21
Typical F Frame “Roll-In” Mounting in User Supplied Enclosure
Alternate Fan Locations
Typical Air Inlet
(2 Places - 1 Each Door)
Pre-Wired DC Bus Inductor
Must be Mounted Separately - Typical Placement Shown
Refer to Figure 2.2 for Wiring Details
Typical Fan Location
(2 Places - 1 Each Door)
Typical Bracket
(May require additional anchoring for shipping)
Suggested Anchoring Point
(M10 Hardware Required)
58.9
(2.32)
107.4
(4.23)
203.2-355.6
(8.00-14.00)
Typical
Length =
465.8 (18.34)
Typical Rail Detail
Suggested Anti-Roll
Anchoring Point
Cable Access Plate
(2 Places)
108.0 x 158.8
(4.25 x 6.25)
Enclosure
Front
196.9
(7.75)
19.1
(0.75)
Important: This information represents the method used to
factory mount an open (roll-in) type Frame F in an enclosure
specifically designed by Allen-Bradley. Illustrations are only
intended to identify structural mounting points and hardware
shapes. You must design and fabricate steel components
based on the actual mounting configuration, calculated
loads and enclosure specifications. Minimum
thickness of all parts = 4.6 (0.18).