Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX - Manual (Page 59)

Chapter
4
Mounting and Wiring Information
Specific to Frames B, C, D, E, F, G,
and H
Chapter Objectives Chapter 4 provides the mounting and wiring information specific to
frames B – H.
Important: If your 1336 IMPACT drive is not a B – H frame size,
skip this chapter and read the mounting and wiring instructions
specific to your frame size. If you do not know what your frame size
is, refer to Chapter 1, Overview.
Wiring the Power The location of the input and output connections depend on the size
of your drive:
This Topic: Starts on Page:
Wiring the power 4-1
Selecting the proper lug kit for your system 4-6
Hard wiring your I/O 4-8
Selecting/verifying fan voltage 4-10
Input fusing requirements 4-11
Dimensions 4-12
If your drive is:
Then, the input and output connections need to be
made:
15 to 30 hp
Through an 11-position terminal block, TB1, located on the
Gate Driver Board.
Over 30 hp At separate terminal strips located at the bottom of the drive.