Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX - Manual (Page 60)

4-2 Mounting and Wiring Information Specific to Frames B, C, D, E, F, G, and H
Figure 4.1
Terminal Block Locations
TB1
TB11
TB3
TB4
TB6
Power Terminal Block
Control & Signal Wiring
Control Interface Option
For factory use only
For factory use only
480V Output (F Frame Only)
Shield Terminals TB1
TB10, 11
TB3
TB4
TB6
TB9
TE
Frames B, C Frames D, E
TB1
TB11
TB3
Control Interface
Option
Control Interface
Option
TB1
TB1
Location
TB1 Location
TB4
TB6
TE
TB1
Frame G
Frame F
U, V, W
& Brake
Terminals
TB10, 11
TB3
Brake
Terminals
R, S, T
TE
TE
PE
Ground
TB10, 11
TB3
TB9
TB1
Location
TB10
TB10
Frame H
U, V, W
& Brake
Terminals
TB10, 11
TB3
+, -
TE
PE Ground
TB1
Location
or 600V depending On Drive Output Volts
!
ATTENTION: The national codes and standards (such
as NEC, VDE, and BSA) and local codes outline
provisions for safely installing electrical equipment.
Installation must comply with specifications regarding
wire type, conductor sizes, branch circuit protection, and
disconnect devices. Failure to do so may result in
personal injury and/or equipment damage.