Rockwell Automation 1747-L55x,D174710.4 SLC 500 Ethernet - Manual (Page 17)

2–5 Setting Up the SLC and PC Hardware
Publication 1747-10.4
Ethernet Channel 1 8-Pin 10Base-T Connector
The Ethernet connector is an RJ45, 10Base-T connector. The pin-out
for the connector is shown below:
Pin Pin Name
1 TD+
2 TD–
3 RD+
4 not used by 10BASE-T
5 not used by 10BASE-T
6 RD–
7 not used by 10BASE-T
8 not used by 10BASE-T
When to use straight-through and cross-over pin-out:
•
SLC 5/05 Ethernet port to 10Base-T Ethernet hub cables utilize a
straight-through pin-out (1-1, 2-2, 3-3, 6-6).
•
Direct point-to-point 10Base-T cables, with cross-over pin-out
(1-3, 2-6, 3-1, 6-2), connect the SLC 5/05 Ethernet port directly
to another SLC 5/05 Ethernet port (or a computer 10Base-T port).
Cables
Shielded and non-shielded twisted-pair 10Base-T cables with RJ45
connectors are supported. The maximum cable length between an
SLC 5/05 Ethernet port and a 10Base-T port on an Ethernet hub
(without repeaters or fiber) is 100 meters (328 feet). However, in an
industrial application, the cable length should be kept to a minimum.
Install RSLogix500 programming software and RSLinx
communication software. Refer to your software package’s
documentation for installation instructions. Be sure to use the
version of the software listed below. Earlier versions of the software
do not support the SLC 5/05 processor.
•
RSLogix500 – Rev. 2.10.12 or later (OS500)
– Rev. 2.51.0 or later (OS501)
•
RSLinx – Rev. 1.70.62 or later
Contact Rockwell Software for information on upgrading your
software.
Load Your Programming
Software