Rockwell Automation 1747-L55x,D174710.4 SLC 500 Ethernet - Manual (Page 53)

5–9 Using RS232-to-Ethernet

Channel-to-Channel Passthru
Publication 1747-10.4
SLC 5/05 #2 Message Setup
•
Channel is set to 1 for Ethernet.
•
Message Timeout for any Ethernet MSG cannot be modified in
the Ethernet Message Setup dialog box. It is assigned by the
processor, and is determined by adding the Channel 1 MSG
Connection Timeout to the MSG Reply Timeout, then adding 5
seconds. This value can be modified by changing one or both of
the timeout values in the channel 1 channel configuration screen.
The modified message timeout applies to all MSG instructions.
•
The Remote Bridge Link ID is the Link ID of Channel 0 of the
SLC 5/05 #1 bridge.
•
The Remote Bridge Address is zero, since the SLC 5/05 #1, as
the bridge, is always node or Source ID 0 for its DF1 channel.
•
The Local Bridge Address is the IP address of the SLC 5/05 #1
bridge.