Rockwell Automation 1756-M02AE Analog Encoder (AE) Servo Module Installation Instructions - Manual (Page 10)

10 Analog Encoder (AE) Servo Module
Publication 1756-IN047D-EN-P - March 2001
Figure 5 Keying Tab.
2. Push the keying tab onto the RTB until it stops.
Note:
To use the RTB in future module applications, you can reposition
the keying tabs on the RTB.
Wiring a Removable Terminal Block
There are two types of RTBs:
• spring clamp
• cage clamp
This section describes how to wire each type of RTB and shows wiring
examples for the AE module.
Wire the RTB before installing it onto the module. Use a 1/8 inch (3.2mm)
maximum flat-bladed screwdriver.
Wedge-shaped
keying tab
Bottom of RTB