Rockwell Automation 1756-M02AE Analog Encoder (AE) Servo Module Installation Instructions - Manual (Page 30)

30 Analog Encoder (AE) Servo Module
Publication 1756-IN047D-EN-P - March 2001
You must remove the RTB before you can remove the module.
To remove the RTB from the module:
1. Unlock the locking tab at the top of the module.
2. Open the RTB door using the bottom tab.
3. Hold the spot marked PULL HERE and pull the RTB toward you and
off the module.
Figure 24 Removing RTB
WARNING
!
When you connect or disconnect the RTB with field
side power applied, an electrical arc can occur. This
could cause an explosion in hazardous location
installations. Be sure that all sources of power are
removed or the area is nonhazardous before proceeding.
POWER
P U L L
H E R
E
D
A
N
G
E
R
P
U
L
L
H
E
R
E
D
A
N
G
E
R