Rockwell Automation 1756-M02AE Analog Encoder (AE) Servo Module Installation Instructions - Manual (Page 11)

Analog Encoder (AE) Servo Module 11
Publication 1756-IN047D-EN-P - March 2001
Wiring a Spring Clamp RTB
To wire a spring clamp RTB:
1. Strip a maximum of 7/16 inch (11mm) of insulation from the end of
your wire.
2. Insert the screwdriver into the outer hole of the RTB.
3. Insert the wire into the open terminal and remove the screwdriver.
Figure 6 Strain Relief Area
4. After you complete field-side wiring, secure the wires in the strain
relief area with a cable-tie.
Wiring a Cage Clamp RTB
To wire a cage clamp RTB:
1. Strip 5/16 - 3/8 inch (8 - 9.5mm) of insulation from the end of your
wire.
2. Insert the screwdriver into the open terminal.
Strain Relief Area