Rockwell Automation 1784-PCD DeviceNet Communication Card - Manual (Page 20)

2-2 Pre-installation Procedures
Publication 1784-IN029C-EN-P - June 2001
System Requirements
Remove Previously Installed Drivers
Always remove PCD drivers you may have installed previously before you install
new ones. Refer to the procedures for uninstalling the driver in the chapter specific
to your operating system.
operating system Microsoft

Windows 95/98/Me, 2000, or NT 4.0
application software RSNetWorx for DeviceNet software
Windows 95/98/Me/NT: RSLinx 2.00.97 or later
Windows 2000: RSLinx 2.2 or later with RSLinx Service Pack 2
installed
Note: For RSLinx versions later than 2.2, no Service Pack is
required for the 1784-PCD card to work.
DeviceNet Manager software version 3.005 or later (16-bit driver
only)
memory for computer resources at least 8 MB
memory for card resources 4KB
IRQ 1 available IRQ
hard disk space 300K
diskette drive one 3.5” diskette drive
PCMCIA slot one Type II slot