Rockwell Automation 1784-PCD DeviceNet Communication Card - Manual (Page 28)

3-6 Install and Use the 16- and 32-bit Drivers for Windows 95
Publication 1784-IN029C-EN-P - June 2001
6. Click Finish. The system begins to load the driver, then prompts you with
the following dialog box:.
You may be prompted to restart your computer for the driver to take effect.
7. For the 32-bit driver, run the PCD Test Utility to verify the installation. Refer
to Chapter 9 of this manual.
8. For the 16-bit driver, follow these instructions to verify the installation:
a. Start DeviceNet Manager Software.
b. Select Utilities
⇒
Set Up Online Communications.
c. Select PCD Interface version 2.2 or Later.
d. Click Ok.
e. Click Test Card.
f. Click Ok.
TIP
If you see this dialog box, specify the drive letter for your disk
drive (usually a:) in the Copy files from... pulldown (see the
screen capture shown above). Press Enter or click OK.
If: Then:
you do not see the message:
All Tests Passed refer to Chapter 10. If your are still having
problems, contact Rockwell Automation
Technical Support.
your computer is not connected to a
DeviceNet network you see the following message on the bottom
of the DeviceNet Manager window:
1784-PCD is not connected to a network or
there is no network power