Rockwell Automation 1784-PCD DeviceNet Communication Card - Manual (Page 26)

3-4 Install and Use the 16- and 32-bit Drivers for Windows 95
Publication 1784-IN029C-EN-P - June 2001
Install the Driver
1. Some earlier versions of the driver do not appear in the Add/Remove
Programs utility on the Windows Control Panel and can only be removed by
running the pcdupdt.exe program. To verify that an earlier version of the
driver is not installed, run the pcdupdt.exe program from the root of the
1784-PCD Installation Windows 95/98/Me 32-bit Setup Disk.
a. Place the 1784-PCD Installation Windows 95/98/2000/Me 32-bit Setup
Disk into your computer’s floppy disk drive.
b. Browse to x:\pcdupdt.exe where x: is your floppy disk drive letter.
c. Double-click on the pcdupdt.exe file to run it.
2. Insert one of the following disks into your floppy disk drive:
•
the disk labelled 1784-PCD Installation Windows 95/98/Me 32-bit Setup
Disk
•
the disk labelled 1784-PCD Installation Windows 95 16-bit Setup Disk
3. Insert the PCD card into your system as described in Chapter 7.
After you insert the card, the system will detect it and begin to build the
driver information needed to run it. To do this, the system must locate the
driver for the card, so it prompts you to specify where to find the driver.
4. Click Next. You see the following dialog box: