Rockwell Automation 1784-PCD DeviceNet Communication Card - Manual (Page 44)

5-2 Install and Use the Driver for Windows NT
Publication 1784-IN029C-EN-P - June 2001
Do You Have Any of the Following Third-Party Plug-and-Play PC
Card Controller Software?
TIP
With certain third-party plug-and-play software packages, two
PCD cards can be used at the same time. To determine if your
system will support two PCD cards, install two cards and
configure the PCD driver in RSLinx (select
Communications
⇒
Configure Drivers). If your system
supports two cards, you will see two serial numbers as shown
in this excerpt from the RSLinx PCD Driver Configuration
Screen.
Native NT (with no third-party plug-and-play software
installed) supports one PCD card at a time.
If: Then:
you do have third-party plug-and-play
card controller software a PC card icon (circled in
this illustration) will
appear on the Windows
task bar
you do not have third-party
plug-and-play card controller software go to page 5-4 and continue with the driver installation.
TIP
To find the version of your third-party plug-and-play software,
you can usually do the following:
1. Double-click the PC card icon.
2. When a dialog box appears, click Help
⇒
About.