Rockwell Automation 1794-ID2 U.MNL INCREMENTAL ENCODER - Manual (Page 28)

2–6 How to Install Your Incremental Encoder Module
Publication 1794ĆUM015B-EN-P - May 2001
5. Repeat the above steps to install the next terminal base.
Panel/Wall Mounting
Installation on a wall or panel consists of:
•
laying out the drilling points on the wall or panel
•
drilling the pilot holes for the mounting screws
•
mounting the adapter mounting plate
•
installing the terminal base units and securing them to the wall or
panel
If you are installing your module into a terminal base unit that is
already installed, proceed to “Mounting the incremental encoder
Module on the Terminal Base” on page2–7.
Use the mounting kit Cat. No. 1794-NM1 for panel/wall mounting.
1.4
(35.5)
1
1794ĆNM1 Mounting Kit
Contents:
1 - Mounting Platefor Adapter
2 - 18 #6 selfĆtapping screws
(2 for theadapter, and 2
each for up to 8 modules)
2
Adapter Module
(not included)
Terminal Base Unit
(not included)
To install the mounting plate on a wall or panel:
1. Lay out the required points on the wall/panel as shown in the
drilling dimension drawing.