Rockwell Automation 1788-FFCT NI-FBUS Configurator User Manual - Manual (Page 29)

1 Publication 1788-UM052B-EN-P - April 2002
Chapter
4
Using the NI-FBUS Configurator
The following sections describe how to use the NI-FBUS Configurator
to configure your fieldbus system.
Starting the NI-FBUS
Configurator Before you use the NI-FBUS Configurator, you must install and
configure your software and any fieldbus interfaces, as instructed in
your getting started manual.
To start the NI-FBUS Configurator, complete the following steps:
1. Select Start ⇒ Programs ⇒ NIFBUS ⇒ NI-FBUS Configurator.
The Add Links window opens.
2. To open an existing project, click Cancel.
OR
To create a new project, select the interface that you want to
connect to from the Added Link(s) checklist and click OK.