Rockwell Automation 1788-FFCT NI-FBUS Configurator User Manual - Manual (Page 61)

Publication 1788-UM052B-EN-P - April 2002
Using the NI-FBUS Configurator 4-33
Verifying a Configuration This section describes two ways to verify your configuration: a quick
verification and a comparison of the configuration to a saved project.
Quick Verification
You can perform a quick check to verify that the parameters on the
bus match those in the project. To verify the configuration of a link,
device, or function block, complete the following steps:
1. Right-click the object to display the popup menu and select
Verify Configuration.
The Verification Test window opens.
2. Click Verify.
The NI-FBUS Configurator compares the function blocks and
project settings, and displays the results in the Result field.
3. If the function blocks do not match the project settings, you can
click Upload Changes to upload the function block parameters
to the project.
4. Click Done.