Rockwell Automation 1788-FFCT NI-FBUS Configurator User Manual - Manual (Page 34)

Publication 1788-UM052B-EN-P - April 2002
4-6 Using the NI-FBUS Configurator
7. After you successfully set the tag, use the Block window to
change the block from OOS mode to a desired mode.
Setting Device Addresses
Complete the following steps to set the device address:
1. In the Project window, select the desired device.
2. Right-click the device or select Devices from the main
menu bar.
IMPORTANT
The operating control system must not be using the
device when you set the address. When you set the
address, the device deletes all communication
information.