Overview, Installing the processor, Overview -2 installing the processor -2 – Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM User Manual
Page 140
Publication AG-UM008C-EN-P - February 2005
4-2 Configuring SLC 5/03, 5/04, and 5/05 Processors
Overview
To configure an SLC 5/03, 5/04, or 5/05 processor:
1. Install the processor; connect the serial cable to channel 0.
2. Define the processor’s communication characteristics using
RSLogix 500 programming software.
3. Install and configure the modem for communication with the
processor; connect the modem to the processor’s serial channel.
Figure 4.1 Configuring an SLC 5/03, 5/04 or 5/05 Processor
Installing the Processor
For details about installing the processor into an I/O chassis, see the
SLC 500 Modular Hardware Style User Manual, publication
1747-UM011. Cable pinouts are shown in each example configuration
as well as in Appendix A.
Figure 4.2 SLC 5/03, 5/04, 5/05 Serial Port Pin Assignments
Modem
Modem
RSLogix 500 Programming Software
RUN
FLT
BATT
FORCE
RUN REM PROG
41191
DH485
SLC 5/03 CPU
RS232
to modem
9-pin female
25-pin
9-pin
DCD.IN 1
8
1
RXD.IN 2
3
2
TXD.OUT 3
2
3
DTR.OUT 4
20
4
SIG.GND 5
7
5
DSR.IN 6
6
6
RTS.OUT
7
4
7
CTS.IN 8
5
8
9-pin female cable connector