Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM - Manual (Page 53)

Publication AG-UM008C-EN-P - February 2005
Configuring Enhanced PLC-5 Processors 2-15
Configuring the Processor
as a Slave Station
To configure the processor as a slave station, place the processor in
program mode and follow the steps below using your programming
software:
Use Table 2.4. to help you understand the communication parameters
you need to specify on the Channel Configuration screen.
Use Worksheet 2.3 (page D-7) for an example configuration and to
record your station’s configuration.
1. Double-click on the Channel
Configuration file to bring up
the Edit Channel Properties
interface.
2. On the Channel 0 tab, choose
System (Slave) for your
Communication Mode.
3. Configure the Serial Port
parameters according to
Table 2.4.
4. Configure the Options
parameters according to
Table 2.4.
5. When all parameters are set,
click OK.