Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM - Manual (Page 291)

Publication AG-UM008C-EN-P - February 2005
Configuring Modems 8-25
Figure 8.15 SRM6200E Front Panel
Data connection for the SRM6200E is via a RJ45 10BASE-T Ethernet
port.
Switch Settings
There are no switches or jumpers to be set or adjusted. The
SRM6000/6100/6200E comes pre configured from the factory. Use the
SRM6000/6100/6200E Users’ Guide (available from DATA-LINC) for
changing configuration in the field.
SRM6000/6100/6200E-SLC
The DATA-LINC SRM6000/6100/6200-SLC are license-free, spread
spectrum frequency-hopping wireless modem that fits directly into the
Allen-Bradley SLC 500 chassis. These modems draw a maximum of
500 mA at 24V dc.
IMPORTANT
SRM6000 Radio Modems can be installed in any
SRM6200E system for use as repeaters (to extend
system range or circumvent line-of-sight problems).
IMPORTANT
For the SRM6000/6100/6200-SLC, the selected
Allen-Bradley chassis power supply must be able to
sustain the current requirements for all devices
installed in the chassis, or communications could be
interrupted.
ANTENNA
L
12VDC
Lx Tx Rx
P C
SRM6200E
Power Carrier
Detect
Transmit
Receive 12VDC
Antenna Linc
Integrity
LAN
Activity
Ethernet
Connection