European community directive compliance, Removal and insertion under power – Rockwell Automation 1797-IJ2 FLEX Ex Frequency Input Module User Manual
Page 6
6 FLEX Ex Frequency Input Module
Publication
1797-5.9 - June 2010
Removal and Insertion Under Power
European Community Directive Compliance
If this product has the CE mark it is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet
the following directives.
EMC Directive
These products are tested to meet the Council Directive 2004/108/EC by
applying the following standards:
EN 61000-6-4:2007, Electromagnetic Compatibility (EMC) - Part 6-4:
Generic Standard for Industrial Environments (Class A)
EN 61000-6-2:2005, Electromagnetic Compatibility (EMC) - Part 6-2:
Generic Standards - Immunity for Industrial Environments
EN61326-1:2006 (Industrial), Electrical Equipment For
Measurement, Control, and Laboratory Use - Industrial EMC
Requirements
WARNING
These modules are designed so you can remove and insert them
under power. However, take special care when removing or
inserting modules in an active process. I/O attached to any module
being removed or inserted can change states due to its input/output
signal changing conditions.
If you insert or remove the terminal base unit while backplane power
is on, an electrical arc can occur. This could cause an explosion in
hazardous location installations.
Be sure that power is removed or the area is nonhazardous before
proceeding.