Rockwell Automation 61C613 16 Channel Analog Input Module - Manual (Page 16)

3Ć4
3.2 Module Replacement
Use the following procedure to replace a module:
Step 1.
Turn off power to the rack and all connections.
Step 2. Remove the connectors from the module.
Step 3. Loosen the screws that hold the module in the rack. Take
the module out of the slot in the rack.
Step 4. Place the module in the antiĆstatic bag it came in, being
careful not to touch the connectors on the back of the
module. Place the module in the cardboard shipping
container.
Step 5. Take the new module out of the antiĆstatic bag, being
careful not to touch the connectors on the back of the
module.
Step 6. Set the address switches for the slot that the module will
be placed in. Refer to table 3.1 or 3.2.
Step 7. Insert the module into the desired slot in the rack. Use a
screwdriver to secure the module into the slot.
Step 8. Attach the 50 pin flat cables to their mating halves on the
module. Attach the cables by aligning the triangle marks
on the cable end and the board socket. Make certain that
the connectors are the proper ones for this module.
Step 9. Turn on power to the rack.
Step 10. Repeat step 7 in section 3.1.