Rockwell Automation 61C613 16 Channel Analog Input Module - Manual (Page 9)

2Ć1
2.0 MECHANICAL/ELECTRICAL
DESCRIPTION
The following is a description of the faceplate, field termination
connectors, and electrical characteristics of the field connections.
2.1 Mechanical Description
The input module is a printed circuit board assembly that plugs into
the backplane of the AutoMate or DCS 5000/AutoMax rack. It
consists of a printed circuit board, a faceplate, and a protective
enclosure. The faceplate contains tabs at the top and bottom to
simplify removing the module from the rack. Module dimensions are
listed in Appendix A. See figure 2.1 for the module faceplate.
The faceplate of the module contains three male connector sockets.
Only the middle and lower connectors are used. Input signals are
brought into the module via two 50Ćwire flat cables. One end of the
cable attaches to the faceplate connector, while the other end of the
cable attaches to the field termination panel (M/N 61C614 or M/N
61C615) for easy field wiring.
On the back of the module are two edge connectors that attach to
the system backplane.