Rockwell Automation 6186-Mxxx Industrial Monitors User Manual - Manual (Page 16)

16 Publication 6186M-UM001J-EN-P - July 2008
Chapter 2 Installing the Monitor
•
Supporting panels must be at least 14 gauge to be sure of proper
sealing against water and dust and to provide proper support.
The mounting hardware supplied accommodates panels up to
6.00 mm (0.236 in.) thick.
Panel Cutout Dimensions
The Cutout Dimensions table lists the panel cutout dimensions for
each monitor. Use the full-size template shipped with each monitor to
mark the cutout dimensions.
Mounting the Monitor in Panel
Follow these directions to mount the monitor in a panel.
1. Cut the panel opening using the appropriate cutout dimensions.
2. Attach the cables to the monitor if access to the rear of the
monitor will not be possible after the installation.
3. Verify that the sealing gasket is properly positioned on the
monitor.
This gasket forms a compression-type seal. Do not use sealing
compounds.
4. Place the monitor in the panel cutout.
ATTENTION
Failure to follow these guidelines may result in personal injury
or damage to the panel components.
Monitor Model Cutout Dimensions, Approx. (H x W)
1200M 238.0 x 318.0 mm (9.37 x 12.51 in.)
1500M 285.6 x 386.6 mm (11.24 x 15.22 in.)
1700M 329.5 x 424.0 mm (12.97 x 16.69 in.)
1900M 363.5 x 449.6 mm (14.31 x 17.70 in.)