Rockwell Automation 6186-Mxxx Industrial Monitors User Manual - Manual (Page 21)

Publication 6186M-UM001J-EN-P - July 2008 21
Installing the Monitor Chapter 2
Mounting the Monitor on a Bench or Tabletop
Follow these directions to mount the monitor to a bench or tabletop.
1. Mount the arm to the bench or tabletop using screws, bolts, or
clamps so the monitor cannot tip.
2. Place the monitor over the arm and insert four M4 x 0.7 screws
through the arm brackets and into the monitor.
The illustration shows the mounting holes for VESA FPMPMI
standard 100 mm interface pad.
3. Tighten the screws.