Rockwell Automation SP120 AC Drive Demo Unit - Manual (Page 10)

3-2 Using the SP200 AC Drive Demo Unit
3.3 How To Display and Adjust Parameter
Values Using the Keypad
The keypad is located on the front panel of the drive demo
unit.
Table 3.2 – Keypad Description
1 The display shows either a parameter number or a parameter value.
The parameter numbers are preceded by either a “P-” or a “d-”.
2
The key toggles between display and program modes. The
PROGRAM LED (5) turns on when the drive is in program mode and
turns off when the drive is in display mode.
3
In display mode, the key scrolls through the display parameters.
In program mode, this key toggles between the parameter number
and parameter value.
4 The RUN LED turns on when the drive is running in either the forward
or reverse direction. The RUN LED flashes while the drive is changing
direction.
5 The PROGRAM LED turns on when the drive is in program mode and
turns off when the drive is in display mode.
6
In display mode, the key decrements the local speed reference.
In program mode, this key decrements the parameter number or
parameter value.
4
2
3
7
5
6
8
9
1
PR OG