Rockwell Automation SP120 AC Drive Demo Unit - Manual (Page 8)

2-2 Using the SP200 AC Drive Demo Unit
2.2 Connecting Power to the Demo Unit
The SP200 AC drive demo unit is powered by a grounded
115 VAC input. Follow these steps to connect the power cord
to the demo unit.
Step 1. Stand the demo unit on a flat surface with the
handle and cover latches facing you.
Step 2. Open both latches and lift the cover. Then slide the
cover to the right to remove.
Step 3. The power cord is stored in the cover of the demo
unit. Press down on the spring-loaded fasteners
inside the cover to access the power cord.
Step 4. Turn the demo unit around and stand it on its feet so
that it faces you.
Step 5. Plug the power cord into the receptacle on the left
side of the demo unit.
Step 6. Plug the power cord into a grounded 115 VAC
outlet.
Step 7. Use the on/off switch located next to the power cord
to apply power to the unit, if necessary.