Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 196)

196 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 7 Bump Test Application
Setting Up and Collecting
Bump Test Measurements This section discusses how to set up, collect, and save Bump Test measurements.
Setting Up Bump Test Measurements
1. Connect the transducer to the Enpac 2500.
Refer to Connect a Transducer to the Data Collector on page 120 .
2. Attach the transducer(s) to the machine case or structure.
3. Select Bump Test on the Main Menu and press the READ/OK key. The
Bump Test screen appears.
4. Select Setup and press the READ/OK key to set up the Bump Test
parameters and begin data collection. The Bump Test - Setup screen
appears.
5. Highlight the option and press the RIGHT ARROW key to open a menu
of choices.
To select an option use the UP and
DOWN ARROW keys.