Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 54)

54 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 1 The Enpac 2500 Data Collector
At this stage, you can see the OS programming occur on the unit.
Remember that this process can take some time. You should see the
firmware upgrade appear on the Enpac 2500 screen.
Once the programming of the new OS is complete, you need to perform a
Hard reset/Cold reboot. See
Restarting the Data Collector on page 57 .
13. Click OK.
14. Disconnect the USB cable.
15. Reconnect the USB cable to re-establish ActiveSync.
16. Click OK.
If ActiveSync hasn’t been reconnected within a few minutes, the OS
Loader will re-prompt for suggested ways to re-connect.