Rockwell Automation Logix5000 Control Systems: Connect PowerFlex 40 Drive over DeviceNet Quick Start - Manual (Page 13)

Rockwell Automation Publication IASIMP-QS028A-EN-P - July 2012 13
Chapter
1
Prepare the PowerFlex 40 Drive Hardware
In this chapter, you learn how to complete the following tasks:
• Wire power to a PowerFlex 40 drive.
• Set the DeviceNet communication card’s operation mode, node address, and
communication rate.
• Connect the communication card to the drive.
• Connect the communication card to the network.
Before You Begin
Before you begin, complete these tasks described in Before Using This Publication on page 5 :
• Prepare the Logix5000 control system hardware - Verify the control system and the
DeviceNet network are powered.
• Prepare the computer
• Configure the network
• Create an RSLogix 5000 project - The example RSLogix 5000 project used in this quick
start uses a CompactLogix 5370 L3 controller.