Rockwell Automation Logix5000 Control Systems: Connect PowerFlex 40 Drive over DeviceNet Quick Start - Manual (Page 20)

20 Rockwell Automation Publication IASIMP-QS028A-EN-P - July 2012
Chapter 1 Prepare the PowerFlex 40 Drive Hardware
6. Tighten the screws.
Connect the Drive to the
DeviceNet Network
1. Connect the 1799-DNC5MMS
5-pin linear to micro male adapter
to the female end of the 1485K-
P1F5-R5 KwikLink right-angle
micro male to micro female
connector cable.
2. Connect the cable to the
DeviceNet connector on the drive.
3. Connect the drive to the
DeviceNet network.
4. Apply power to the drive.
0.5…0.6 Nm
(4…5 lb-in)