Rockwell Automation Logix5000 Control Systems: Connect PowerFlex 40 Drive over DeviceNet Quick Start - Manual (Page 40)

40 Rockwell Automation Publication IASIMP-QS028A-EN-P - July 2012
Chapter 3 Use a PowerFlex 40 Drive in an RSLogix 5000 Project
Before You Begin
Before you begin, you must complete these tasks:
• These tasks described in Before Using This Publication on page 5 :
– Prepare the Logix5000 control system hardware
– Prepare the computer
– Configure the network
– Create an RSLogix 5000 project
• These tasks described in Chapter 1, Prepare the PowerFlex 40 Drive Hardware on page 13 :
– Mount the Drive
– Wire Power to the Drive
– Set the Drive Operation, Node Address, and Communication Rate
– Connect the DeviceNet Adapter to the Drive
– Connect the Drive to the DeviceNet Network
• These tasks described in Chapter 2 , Create DeviceNet Network Software Files on page 21 :
– Set the 1769-SDN Scanner Module’s Node Address
– Create a DeviceNet Configuration File
– Create a DeviceNet Scanlist