Rockwell Automation Logix5000 Control Systems: Connect PowerFlex 40 Drive over DeviceNet Quick Start - Manual (Page 18)

18 Rockwell Automation Publication IASIMP-QS028A-EN-P - July 2012
Chapter 1 Prepare the PowerFlex 40 Drive Hardware
3. Adjust the rate switches the same
way as the node switches
described in
step 2 to set the
baud rate.
4. Use the following table to set the
communication rate.
This quick start uses Autobaud.
Rate Switch
7 8
125 Kbps 0 0
250 Kbps 1 0
500 Kbps 0 1
Autobaud 1 1
2 1 8 3 4 5 6 7
RATE
UP = OPEN = 1
8 7
Autobaud Rate