Rockwell Automation Logix5000 Control Systems: Connect PowerFlex 40 Drive over DeviceNet Quick Start - Manual (Page 35)

Rockwell Automation Publication IASIMP-QS028A-EN-P - July 2012 35
Create DeviceNet Network Software Files Chapter 2
Create a DeviceNet Scanlist
1. Verify that the controller’s mode
switch is in the PROG position.
2. In your RSLogix 5000 project,
right-click the scanner module and
choose Properties.
3. On the RSNetWorx tab, click the
Launch RSNetWorx for
DeviceNet icon.
The RSNetWorx for DeviceNet
software appears with the
DeviceNet file listed in the
DeviceNet File (.dnt) field open.
RUN
REM
PROG