Rockwell Automation EK-44750C Enwatch Unit - Manual (Page 21)

Rockwell Automation Publication GMSI10-IN001A-EN-P - May 2013
Enwatch Unit 21
2. Select Setup>Transducer to select the “Temperature” transducer in the
collection specification.
3. In the Emonitor software, define a numeric measurement definition with
the temperature units and the “Temperature” collection specification.
Transducer Bias Reading
The Enwatch board can take transducer bias readings; however, this is not a
transducer check function that detects transducer failure before taking data. The
bias reading is an independent reading with a different signal path on the
Enwatch board.
1. In the Emonitor software, select Setup>Transducer.
2. To define a new transducer name (for example, “Transducer Check”) click
New.
3. Enter a name and click OK.