Rockwell Automation EK-44750C Enwatch Unit - Manual (Page 25)

Rockwell Automation Publication GMSI10-IN001A-EN-P - May 2013
Enwatch Unit 25
Configure and Enwatch Board
with Emonitor Software The Enwatch unit is specially designed to operate over an Ethernet connection.
Each Enwatch unit has a unique IP address that can be changed through the
RS232 port inside the unit. Ideally, one Enwatch unload station can serve an
unlimited number of Enwatch units. However, to improve unload speed,
multiple Enwatch unload stations are suggested.
Each Enwatch unit has 16 vibration channels and 4 tachometer channels. In
addition, the Allen Bradley Enlive software (live mode analysis) can be used to
“lock onto” one channel at a time. During live mode analysis, regularly scheduled
unload continues to unload whatever data is in the Enwatch unit buffers before
entering live mode analysis. The Enlive software has a default timeout of 30
minutes to prevent an extended break in unloading scheduled data.
For more information on setting up an Enwatch unit in an Emonitor system,
refer to the Emonitor User's Guide, publication
EMONTR-UM001 .
Add an Enwatch Unload Station The Unload Station Manager is a graphical representation of all of the Enwatch
units on your network. It is used for Enwatch configuration of Enwatch IP
addresses, subnet address, and mapping measurement points to Enwatch
channels.
1. Click Start>All Programs>Rockwell Software>Emonitor>Online Data
Management Console.
The Online Data Management Console opens.
2. Enter your User Name and Password and click OK.
3. To create a new data source, click New.
4. For Type, enter Enwatch/6600 Online Data.